zwave-js/node-zwave-js v10.13.0

Release v10.13.0

on GitHub

Features

• Added convenience method to set time, date and timezone on nodes (#5584)
• Allow notification events to idle related notification variables. This solves a long-standing issue where locks could appear stuck in "Lock jammed" state, because they never sent an idle notification. (#5630)

Bugfixes

• Added a new Door state (simple) notification value, which has the old behavior of the Door state value with just two states and can be turned into a binary sensor (#5614)
• Node statistics are now only updated using valid TX reports (#5613)
• During interview of Schedule Entry Lock CC, set timezone if necessary and supported (#5585)
• Value timestamps are no longer updated for optimistic value updates caused by the driver itself (#5581)
• Communication with nodes using Security S2 will always use S2 now, even if the respective CC may also be supported insecurely (#5579)
• Introduce delays and reduce polling frequency in health checks to avoid collisions causing S2 desync (#5628)
• Assume Notification CC is operating in push mode, unless proven otherwise (#5627)
• Fixed a typo in the logs when a Multilevel Sensor Report with an unsupported scale is received and discarded (#5623)
• When querying a sensor reading, try to reuse the last reported sensor scale before defaulting to the first supported scale (#5622)

Config file changes

• Add Vesternet branded Z-Wave devices (#5567)
• Add product ID 0x1351 for MCOHome A8-9 (#5595)
• Add fingerprint 0x8109-0x4dd5 to Yale YRD-256-ZW3 (#5604)
• Disable scale validation for MCOHome MH10-PM2.5-WA/WD (#5624)

Changes under the hood

• Config files may now have overlapping firmware version ranges, e.g. for white-labeling specific firmware versions, but only if one of them is marked as preferred (#5617, #5619)