Pre-release:
First attempt at complete setup other than EPS modes based off the Serial Number. (Thanks for everyone who submitted serial Numbers and Charge/Discharge Values over at #26)
I would recommend removing the Integration from the Integration page before updating.
If you rename it the same after re-adding it, your sensor names should not be affected.
On first try do not set any of the tick boxes for Machine type.
ie Gen2 X1 or Gen3 X3 etc, leave them all blank.
Charge / Discharge rate now set based on Serial.
So SK-SU & SK-TL no longer share 50A the SK-TL should now self configure to 100A
"Total Solar Energy" for the Gen2 is on by Default other than for the earlier U50EC which is removed from the Integration.
"Total Solar Energy" Can now be used for the Energy Dashboard on the Gen2
Gen2 Users should now have a complete set of sensors for the Energy Dashboard other than the U50EC
X1-AC has been setup the same as a normal Gen3 X1 for now. All the PV related sensors will either show 0 or Unknown. This will be later cleaned up.
If the Integration fails to load with the following error in your log "unrecognized inverter type - serial number : {your_serial_number_here}"
Please see #26 providing the details asked for.
Massive thanks to @infradom for helping in achieving my goal of moving away from Tick Boxes on Integration Setup.
I really appreciate all the help you have provided 🥇