⚠️ BREAKING CHANGES — READ THIS BEFORE UPDATING! ⚠️

This version contains two major, breaking changes:

• The Bluetooth Proxy component has been removed from the stock firmware due to performance issues reported by several users. You can re-add the component if you wish: More Info
• The firmware is now compiled using the ESP-IDF framework instead of Arduino. This should offer better performance (especially if you re-enable the Bluetooth Proxy component) but has some implications for flashing. Read below to understand them and avoid bricking your Upsy Desky.

Please report any issues you experience with this new version.

Flashing Instructions

Due to the switch from Arduino to ESP-IDF, the partition structure of the binaries are different. This means you CANNOT cleanly OTA this firmware over any other previous version; you MUST flash via USB.

If you are using ESPHome Dashboard, physically plug the device into your computer and flash the new firmware using the web UI.

If you are not using ESPHome Dashboard (i.e., totally stock firmware), you must install the firmware via USB. Note that this will factory reset your Upsy Desky and you will need to go through the setup process again. More info is available here