sei-protocol/sei-chain v6.7.3

on GitHub

ℹ️ This is not a mandatory upgrade, but we recommend that all pacific-1 and atlantic-2 validators and node operators update to v6.7.3. There is no governance proposal and no coordinated chain halt for this update.

v6.7.3 is a patch release on top of v6.7.2. It moves the state sync trust period from config.toml into seid, so every node on a network uses the same value. The trust period must stay shorter than the unbonding time. With the value built into the binary, the network can shorten its unbonding time without every operator editing config.toml.

⚠️ Check Before You Update

• seid now ignores trust-period in the [statesync] section of config.toml. State sync uses a trust period of 112 hours on pacific-1, atlantic-2 and arctic-1. If config.toml sets trust-period to another value, seid start logs a warning that begins with statesync.trust-period is set in config.toml each time the node starts. Earlier seid versions wrote trust-period = "168h0m0s" into config.toml, so most nodes will log this warning. To stop it, remove the trust-period line. The node runs normally with or without the line (#4690).
• If you use state sync, use a recent trust height. The block at trust-height must be less than 112 hours old. If it is older, state sync fails with old header has expired. Before v6.7.3, the limit was the trust-period value, which was 168 hours by default.

✅ How to Update

1. Build v6.7.3 with git fetch --tags && git checkout v6.7.3 && make install.
2. Stop the node.
3. Replace the seid binary with v6.7.3. If you use Cosmovisor, replace the binary in upgrades/v6.7/bin/.
4. Optional: remove the trust-period line from the [statesync] section of config.toml.
5. Start the node.
6. Make sure that seid version shows v6.7.3.
7. Make sure that the node syncs new blocks.

What's Changed

• Backport release/v6.7: Hard-code the state sync trust period per chain by @seidroid[bot] in #4690
• Backport deterministic simulation limiter test fix to v6.7 by @masih in #4702

Full Changelog: v6.7.2...v6.7.3

Experimental Pre-built Binaries

Pre-built statically-linked seid binaries attached below for linux/amd64
and linux/arm64.

Verify your download:

sha256sum -c checksums.txt --ignore-missing

For Docker images, see ghcr.io/sei-protocol/sei.