This release moves away from polling and into Websockets!
This means near-realtime updates but it also means considerations for your local hardware.
Setting HA Inform Rate (Default 30 sec)
• Too aggressive (low interval): increases CPU/memory load, DB writes (impacting SD/ssd endurance), and can overwhelm local hardware — especially on smaller platforms.
• Too conservative (high interval): stale data, slower detection of device state changes, delayed config pushes
• Recommended starting point: 30–60s for most deployments; adjust based on device count and hardware capability
• Monitor resource usage (CPU, memory, DB writes) after any HA inform rate change and adjust accordingly
Note that "Read Only" has been renamed "Allow Breaker Control" and will be off by default, Please reenable if required.
This build has seen a lot of backend changes and has been extensively tested, but it's marked "RC" out of caution. Please report any issues.
This release will hopefully address Leviton's concerns, but time will tell.