github rinkhals-community/Rinkhals 20261118_01_test
Rinkhals 20261118_01_test

latest release: 20261118_02_test
pre-releaseone hour ago

Greetings Citizens of Rinkhalsvania!

This is a fourth test build on the way to the next release. It has everything from 20261117_01_test, plus two things that come out of running real Klipper on the printer with the Klipper (vanilla) app.

What's new since 20261117_01_test

  • Apps can now depend on other apps (#246, #247). An app can say which other apps it can't work without, and Rinkhals keeps that intact from the touch screen, the web portal and at startup:

    • An app can't be installed or enabled until what it depends on is installed and enabled.
    • An app can't be disabled or uninstalled while another app still needs it.
    • At startup, apps start after the apps they depend on.

    Rinkhals never installs or removes anything for you... it tells you which app is in the way. The first app to use this is the new HelixScreen app, which needs Klipper (vanilla) or a tunneled Klipper. None of the built-in apps depends on another, so nothing changes if you don't use such an app.

  • The printer's light can be switched while Klipper is running (#245). With the Klipper (vanilla) or tunneled Klipper apps, the light in Mainsail and Fluidd showed a state but did nothing, because it asked Anycubic's firmware, which isn't running then. It now switches the light directly in that case. With Anycubic's firmware running, nothing changes.

Please help us test

  • Does Rinkhals start normally, and does the Rinkhals entry in Settings open the Rinkhals menu?
  • Do your apps still start at boot like before, and can you enable and disable them from the touch screen and the web portal?
  • Do Mainsail or Fluidd connect, and does a print from your slicer start and finish normally?
  • If you use Klipper (vanilla) on a Kobra S1: with Klipper (vanilla) 1.4.0 or later, does the Chamber Light switch in Mainsail turn the light on and off?
  • Kobra S1 and S1 Max owners on the new firmware: everything from the earlier test builds still applies, see #234.

We tested the app dependency rules and the light on our Kobra S1. The new messages on the touch screen and in the web portal's Apps page haven't been tried on a printer yet, and the light hasn't been tried on the Kobra 3 family... so those are the places we'd most like to hear about.

If something doesn't work, a debug bundle from the Management page of the Rinkhals web portal (http://<printer-ip>:8090) would help a lot.

Known issues

These are open and not fixed in this release.

  • On the Kobra S1 with 2.7.3.7, the Mainsail and Fluidd Heightmap shows the saved mesh instead of the live one during a print. The live view stays limited to 2.7.2.7 until we've checked it on the new firmware.
  • #205 - on the Kobra S1 Max, the head still stays over the last probe point after a calibration started from Mainsail. It doesn't affect the mesh.

Report findings to https://github.com/rinkhals-community/Rinkhals/issues with a debug bundle.

Full Changelog: 20261117_01_test...20261118_01_test

Don't miss a new Rinkhals release

NewReleases is sending notifications on new releases.