github rinkhals-community/Rinkhals 20261117_01_test
Rinkhals 20261117_01_test

pre-releaseone hour ago

Greetings Citizens of Rinkhalsvania!

This is a third test build on the way to the next release. It has everything from 20261116_02_test, including support for Kobra S1 2.7.3.7 and Kobra S1 Max 2.7.2.6, plus the fixes below.

What's new since 20261116_02_test

  • A power cut while Rinkhals is starting can no longer leave Anycubic's programs damaged (#198, #240). On every boot Rinkhals patches gkapi and the touchscreen program, and none of that was written to flash safely, so losing power at the wrong moment could leave a cut-off copy behind that the next boot kept. The stock files are now never deleted, the patched copy is checked before it's used, and a damaged copy is replaced from the original. This affects every model.
  • The web portal won't install or update while Klipper is running on another computer (#241). With the tunneled-klipper or LAN tunnel apps, the printer can't see a print the other computer is running, and an update's reboot would cut it off. The Apps and Firmware pages now say so and hold off until the tunnel app is stopped.
  • The printer's mDNS responder no longer gets stuck on a malformed network packet (#222, thanks mane).

Please help us test

  • Does Rinkhals start normally, and does the Rinkhals entry in Settings open the Rinkhals menu?
  • Do Mainsail or Fluidd connect, and does a print from your slicer start and finish normally?
  • Kobra S1 and S1 Max owners on the new firmware: everything from the last two test builds still applies, see #234.

If something doesn't work, a debug bundle from the Management page of the Rinkhals web portal (http://<printer-ip>:8090) would help a lot.

Known issues

These are open and not fixed in this release.

  • On the Kobra S1 with 2.7.3.7, the Mainsail and Fluidd Heightmap shows the saved mesh instead of the live one during a print. The live view stays limited to 2.7.2.7 until we've checked it on the new firmware.
  • #205 - on the Kobra S1 Max, the head still stays over the last probe point after a calibration started from Mainsail. It doesn't affect the mesh.

Report findings to https://github.com/rinkhals-community/Rinkhals/issues with a debug bundle.

Full Changelog: 20261116_02_test...20261117_01_test

Don't miss a new Rinkhals release

NewReleases is sending notifications on new releases.