Greetings Citizens of Rinkhalsvania!
This is a second test build for the new Anycubic firmwares. It has everything from 20261116_01_test (support for Kobra S1 2.7.3.7 and Kobra S1 Max 2.7.2.6) plus two fixes for bed mesh calibration on the Kobra S1.
What's new since 20261116_01_test
- Kobra S1: a bed mesh calibrated from a cold printer is no longer about 0.3 mm too high. The S1 finds Z with the nozzle probe, and the calibration from Mainsail or Fluidd homed before heating up, then probed hot. The bed and head grow as they heat, so the saved mesh came out high, and prints (which home hot) used it that way. The calibration now homes Z again once everything is hot, right before probing. On our S1 a cold-start calibration went from +0.32 mm at the bed center to +0.00.
- Kobra S1: the head parks over the purge chute after a calibration instead of staying over the last probe point (#205).
If you calibrated your S1 from Mainsail or Fluidd on a cold printer, it's worth running the calibration again with this build.
Please help us test
We've run the Kobra S1 build on our own S1 with 2.7.3.7. The S1 Max patches are built and checked from the firmware files, but haven't been on a printer yet... if you're on either one, please install this build and tell us how it went on the pull request, #234.
One tip for S1 owners: 2.7.3.7 also brings new firmware for the print head board, and on our printer it only took effect after we turned the printer off at the power switch and back on. A reboot from the screen wasn't enough. If you updated and haven't done a full power-off since, it's worth doing once.
- Does Rinkhals start, and does the Rinkhals entry in Settings open the Rinkhals menu?
- Do Mainsail or Fluidd connect, and does a print from your slicer start and finish normally?
- Kobra S1 owners: does a calibration from Mainsail (Heightmap, Calibrate) finish, save, and park the head over the chute? Does your first layer look right with the new mesh?
- Cloud to LAN bridge users: the new firmware changed how LAN mode is handled, so please check that the bridge still connects and that your printer stays in your Anycubic account.
- Kobra S1 Max owners: does a bed mesh calibration from Mainsail still finish and save?
If something doesn't work, a debug bundle from the Management page of the Rinkhals web portal (http://<printer-ip>:8090) would help a lot.
Known issues
These are open and not fixed in this release.
- On the Kobra S1 with 2.7.3.7, the Mainsail and Fluidd Heightmap shows the saved mesh instead of the live one during a print. The live view stays limited to 2.7.2.7 until we've checked it on the new firmware.
- #205 - on the Kobra S1 Max, the head still stays over the last probe point after a calibration started from Mainsail. It doesn't affect the mesh.
Report findings to https://github.com/rinkhals-community/Rinkhals/issues with a debug bundle.
Full Changelog: 20261116_01_test...20261116_02_test