This release updates HelixScreen to 1.0.10-4 and Klipper (vanilla) to 1.4.1. The other apps are unchanged from 20261118_07.
-
HelixScreen recovers when it comes up with a dead-looking screen (#60). After a reboot, HelixScreen could start while Klipper was still too busy to answer. The screen then took your touches, but nothing on it ever changed: no temperatures, no states, no chamber light. Restarting the app by hand fixed it. The app now notices this in HelixScreen's log during the first five minutes after a start, and restarts HelixScreen by itself.
- It tries twice at most. If Klipper still doesn't answer, it leaves HelixScreen alone and says so in the Rinkhals log.
- Nothing extra runs after those five minutes.
-
Klipper (vanilla) reports its version (#59). Klipper used to report its version as
?, so Mainsail, Fluidd and HelixScreen couldn't tell you which Klipper was running. It now reports the version of Kobra-S1's Klipper that the app ships,V1.3.1-54-g880188bin this release.- Moonraker had the same gap. That fix is in Rinkhals itself and comes with the next Rinkhals test release.
We saw the dead-looking screen once on our Kobra S1, after an update's reboot. We tested the fix there by writing the failure into HelixScreen's log by hand: the app restarted HelixScreen within 15 seconds. We haven't seen it recover from a real failed start yet, because the next reboot started cleanly. The version was checked on the same printer.
What's Changed
- fix(vanilla-klipper): tell Klipper which version it is by @martinbogo in #59
- fix(helixscreen): start HelixScreen again when Klipper didn't answer its status request by @martinbogo in #60
Full Changelog: 20261118_07...20261118_08