This release adds a new app, HelixScreen. The other apps are unchanged from 20261118_03.
New: HelixScreen
HelixScreen is a touch screen interface for Klipper, and this app puts it on the printer's own screen in place of Anycubic's: print files, temperatures and fans, the ACE Pro with its dryer, the chamber light, bed mesh, macros and more.
Please read this before installing it:
- Kobra S1 only for now. That's the only printer we've run it on. On other models it installs but doesn't start. The Kobra 3 family's screen is smaller, rotated and resistive, and needs its own settings... if you have one and want to help, tell us.
- It needs Klipper (vanilla), or a tunneled Klipper, installed and running. It won't install without one. It does not work with Anycubic's own firmware.
- It takes over the screen. While it's running, Anycubic's interface is stopped, so Wi-Fi setup, Anycubic firmware updates and the Rinkhals touch menu aren't reachable from the screen. Use the Rinkhals web portal (
http://<printer-ip>:8090) for apps and updates. To get Anycubic's screen back, disable the app from the portal. - If Klipper goes away, so does HelixScreen. When you stop or remove your Klipper app, or Klipper (vanilla) can't start and falls back to Anycubic's firmware, Anycubic's screen comes back within about ten seconds. HelixScreen returns by itself once Klipper is running again.
With Klipper (vanilla) there's nothing to set up: the printer, the ACE Pro and the chamber light are found on their own. With a tunneled Klipper, open the app's settings, set "Moonraker host" to the address of the machine running Klipper, then restart the app.
The chamber light button needs Klipper (vanilla) 1.4.0 or later and a Rinkhals build newer than 20261117_01_test.
HelixScreen uses about 20 MB of memory, where Anycubic's interface uses 40 MB or more. The download is about 55 MB.
What we haven't tested yet
This is a first release, and we'd rather tell you what's unproven:
- A whole print with HelixScreen on the screen, and how much CPU it takes then. These printers have one core, shared with Klipper.
- Installing it from the app store or a USB stick. We copied it to our printer by hand.
- A tunneled Klipper setup.
- The screen going to sleep and waking up.
If you try it, please tell us how it went, good or bad.
What's Changed
- feat(helixscreen): HelixScreen as an app, on top of Klipper (vanilla) or a tunneled Klipper by @martinbogo in #53
- docs(helixscreen): say in the store description what to set for a tunneled Klipper by @martinbogo in #54
- fix(helixscreen): never hold the screen while GoKlipper runs the printer by @martinbogo in #55
Full Changelog: 20261118_03...20261118_04