github rinkhals-community/Rinkhals.Apps 20261117_05
Rinkhals.Apps 20261117_05

one hour ago

This release updates Klipper (vanilla) to 1.3.0. The other apps are unchanged from 20261117_04.

  • Input shaper calibration now works on the printer. SHAPER_CALIBRATE, TEST_RESONANCES and MEASURE_AXES_NOISE used to fail with "Failed to import numpy". The app now ships a small compiled program that does the same calculation, so you can measure your own printer's resonances with its built-in accelerometer: home, run SHAPER_CALIBRATE, then SAVE_CONFIG. This is for the Kobra 3, Kobra 3 Max and Kobra S1; the Kobra 2 Pro config has no accelerometer. Run it with the printer idle, never during a print.
  • Heater PID values now come from your own printer. The shipped configs carried PID values tuned on another printer, which could leave the nozzle swinging around its target and make print starts wait for minutes. When Klipper starts, the app now replaces them with the calibration GoKlipper keeps for your printer. Values you've changed yourself, including a saved PID_CALIBRATE, are left alone.

The calibration results match Klipper's own numpy code to nine digits on simulated data, and a full SHAPER_CALIBRATE run on a Kobra S1 gave 3hump_ei at 80.4 Hz and mzv at 38.4 Hz... Anycubic's firmware had stored 3hump_ei at 81.2 Hz and mzv at 39.4 Hz for the same printer. We haven't run it on a Kobra 3 or Kobra 3 Max, which use two accelerometers. The PID change was tested against config files from all four models, but not yet on a first start of a real printer. Reports welcome.

What's Changed

  • feat(vanilla-klipper): use the printer's own heater PID calibration by @martinbogo in #48
  • feat(vanilla-klipper): input shaper calibration on the printer, without numpy by @martinbogo in #49

Full Changelog: 20261117_04...20261117_05

Don't miss a new Rinkhals.Apps release

NewReleases is sending notifications on new releases.