This release adds Kobra-S1's (Antirad's) four Klipper apps to the store. The other apps are unchanged from 20261101_03.
- Klipper (vanilla) 1.2.0 runs mainline Klipper on the printer in place of Anycubic's GoKlipper, with ACE Pro and ACE 2 Pro support and the ACE dashboard at
http://<printer ip>/ace/ace.html. It's built from Kobra-S1's Klipper fork and ACEPRO, and new commits there now come through as update PRs on their own. If Klipper doesn't come up within 3 minutes, the app starts GoKlipper again and logs why, so a bad config won't leave you without a working printer. Its log is KLIPPY.LOG in Mainsail and Fluidd. - tunneled-klipper 2.2 forwards the printer's MCU serial ports so Klipper can run on another computer.
- Lan Tunnel KS1 0.2 does the same over TCP ports 7003 and 7005. With a static address set in its settings, it now listens only on that address instead of on every interface the printer has.
- KlipperScreen Viewer 1.0.0 shows a KlipperScreen running on another computer on the printer's touchscreen, over VNC.
Vanilla Klipper was tested on a Kobra S1: it starts, homes, serves the ACE dashboard, falls back to GoKlipper on a broken config, and uninstalls cleanly. We haven't run a print or loaded filament through the ACE with it yet, and haven't tested the K3, K3 Max or Kobra 2 Pro. The other three apps need a separate computer running Klipper or KlipperScreen and are untested by us. Reports welcome.
What's Changed
- Bring Kobra-S1's Klipper apps into the store by @martinbogo in #44, carrying over @Kobra-S1's #22
Full Changelog: 20261101_03...20261117_01