This release only changes the Cloud to LAN bridge (now 1.2). The other apps are unchanged from 20261101_02.
The bridge can now show the printer's camera in the Anycubic app while the printer is in LAN mode, thanks to @jakewalklate's work in #11 (carried over as #42). Status, controls and the camera all work through the Anycubic cloud as they would in cloud mode.
Turn on LAN mode from the bridge's own setting, not from the touchscreen. On recent firmware (seen on the Kobra S1 with 2.7.2.7), the touchscreen's LAN mode toggle also removes the printer from your Anycubic account, and the Anycubic app then shows "Scan to add device". The bridge now has a "LAN mode" setting (Settings > Rinkhals > Apps > Cloud to LAN bridge > settings) that switches to LAN mode and keeps the printer on your account. Reboot the printer after changing it, since the touchscreen only reads the mode when it starts and its toggle shows the old state until then. If your printer already disappeared from the app, switch back to cloud mode, scan the QR code again, then use the bridge's setting. The Anycubic app in LAN mode guide has the details.
This version also fixes the bridge running twice after switching to cloud mode and back, and it no longer writes the camera's credentials to its log.
What's Changed
- [cloud2lan-bridge] Add support for cloud camera in anycubic app (from #11) by @martinbogo in #42
Full Changelog: 20261101_02...20261101_03