V4.0.1 LoRa APRS Tracker Update
- LoRa TX Power can now be set from the WebUI for each LoRa profile (EU/WORLD, POLAND, UK, US). The value is validated for each radio chip (SX127x: 2-17 or 20 dBm / SX126x and LLCC68: up to 22 dBm) and saved as the power the radio really uses.
- ⚠️ SX1262/SX1268 boards (not 1W): the firmware no longer adds +2 dBm to the configured power. With the default config (20 dBm) these trackers now transmit at 20 dBm instead of 22 dBm. You can set 22 dBm from the WebUI if you need it.
- T-Beam 1W: PA ramp time is kept after every LoRa profile change.
- A failed LoRa power setting no longer hangs the tracker.
- Tracker Digipeater mode now repeats WIDE1-1 only (fill-in digi), no matter which path is used for the beacons.
- Fixed message IDs being repeated after a message ran out of ack retries.
- Messages with "{" but without message ID are no longer answered with an empty "ack".
- New Board: Hydra DIY (ESP32 + GPS + 1W E22-400M30S), with battery reading on screen.
- New Board: T-Beam V1.x (AXP192) with SX1262.
- New Board: Heltec Wireless Stick Lite V3 as TNC (no display).
- Heltec V2: battery shown on main screen, and Flashlight no longer touches any pin when disabled.
- APRSPacketLib update to 1.0.10 (numeric overlay fix on compressed beacons).
- Libraries update.