Interesting changes since the last release:
- Remove POWER_OFF_ON_HALT config line and use board default - Pi5 is 0 and CM5 / Pi500 is 1.
- Set NET_INSTALL_AT_POWER_ON=1 in the imager EEPROM config
- RP1 firmware - Add support for Linux PIO driver
- Change initial_turbo default from 0 to 60 to reduce boot time.
- Remove unnecessary 1 second delay in DWC host-mode setup.
- network-install - fix keyboard detection on hubs
- recovery.bin - Always enable UART output