Drawing
- Two-zone units: each zone goes back to the indoor unit on its own return, and the house is split in two floors, the direct zone upstairs and the mixed zone downstairs. Thanks @pvodoz.
- No hot water tank: when its values are not selected, or the tank sensor reads below 0 °C (not connected), the tank and the 3-way valve leave the drawing. The same for the room. Thanks @threeplank and @rogervdh.
- The Hybrid, the EBLQ 5-7kW monobloc and the EWAQ mini chiller now show their leaving water, and the Hybrid its room temperature. Thanks @thehijacker.
- Rotex protocol S: "D(C)" is the leaving water, and is now named so (its Home Assistant entity gets a new id). Thanks @TungstenE2.
- A water pressure of exactly 0 bar (no sensor on the unit) shows as no reading.
Default selection: everything the drawing uses, including the backup heater and, on two-zone units (found by the survey), the mixed water, both pumps and the second zone's target. Existing selections do not change.
Boards: the M5Stack Atom Lite keeps its WiFi at 15 dBm, stable with its small antenna. Thanks @forTT78.
System page: the heat pump tile reads "34 values, read 9 s ago".
Home Assistant card: v1.0.9.