pascallanger/DIY-Multiprotocol-TX-Module v1.3.2.77

Multiprotocol v1.3.2.77

on GitHub

Change Log since v1.3.2.61

• DSM/DSMR
  • New DSMR subprotocol for DSMR surface receivers
  • Only 22 IDs available, use RX num to cycle through them
  • Telemetry enabled
• Pelikan/SCX24
  • New SCX24 subprotocol for 3 channels surface receivers
  • TX: Axial AX-4 2.4GHz transmitter and Panda Hobby 3CH Smart Radio 2.4GHz (MT-305A) and Models: Axial SCX24: Deadbolt, Jeep Wranger Rubicon, Chevrolet 1967 C10, B-17 Betty and Panda Hobby: Tetra K1, X1, X2
• OMP
  • The OMP protocol now supports telemetry using the CC2500 (was using the NRF24L01 previously)
  • If the CC2500 RF component is not installed then the NRF24L01 will be used including telemetry.
• MT99XX/Dragon
  • Added telemetry: A1 = battery voltage with a Ratio of 25.5, A2=battery low flag (0=off,>0=on) and RSSI = dummy value of 100
• DSM
  • Added a table detailling the different RX output ranges based on the radio settings
• E016H
  • Separated protocol from E01X due to the different structure
• Hitec
  • Fixed RF tunning
• Kyosho/FHSS
  • Fixed protocol after the introduction of sub protocol Hype
• Devo
  • Fixed GPS year
• FrSkyX2
  • Updated bind to work with some new RXs code
• CABELL
  • Protocol optimization: 1.5KB saved, thanks Mike!
• Multi core
  • XN297 emulation layer changed
    • Loads of protocols have been touched by this change. Some testing has been done but please test on all your models
    • The XN297 emulation selects in this order:
      • the CC2500 if it is available and bitrate=250K. Configure the option field automatically for RF tune
        • CC2500 can now receive XN297 normal and enhanced payloads
      • the NRF for all bitrates if it is available
      • if NRF is not available and bitrate=1M then an invalid protocol is sent automatically to the radio
    • CC2500 only modules have more protocols/subprotocols available: MJXQ, MT99XX, Q303 and XK
  • Packed protocols defintion: 400 bytes saved

Flashing these firmwares from a computer require Flash Multi v0.6.1 or newer, check the Firmware updates manual and troubleshooting section if you have issues.