Change Log since v1.3.2.12
- M-Link
- New protocol supporting 16 channels
- Extended limits supported
- Failsafe supported but read the doc!!
- Telemetry: some sort of support from the 2 RXs I have
- Excluded from the T18 5in1 build due to limited Flash space
- MT99xx
- Added the sub protocol A180 for the XK A180 plane
- WFLY2
- Failsafe now supports Hold and No pulses
- Bayang
- If supported by the Silverware telemetry the PID values are appearing as sensors: AccX=P, AccY=I, AccZ=D (you can rename the sensors after the discovery)
- FrSky RX
- Added the sub protocol EraseTX to remove any CloneTX information from the module
- Futaba S-FHSS
- Fixed: failsafe was reversed and not having the right range
- DSM
- Fixed low power which was not set correctly after a reboot
Flashing these firmwares require Flash Multi v0.6.1 or newer, check the Firmware updates manual and troubleshooting section if you have issues.