Support
If you use the firmware please consider a donation to support further development. Thank you for your continuous support
Changes from 2.14.2 to 2.14.3
- Roller Shutter/Window Cover Mode: Add option to Display as Window in HomeKit, thanks to @esadrian
- +UNI: Fix unusable Input pins
- +UNI: Outputs are swapped to match Hardware Pinout description
- +2PM: Addon Support for Digital Input Pin
- +2PM: use partition layout to directly update from 1.6 Stock. Careful This breaks the direct update path for +2PM devices with HomeKit firmware. To update your device please hit revert first then update the stock firmware and once again flash to ShellyHomekit. During this process your HomeKit pairing is not lost. However, if you do not need the new features, it is not recommended to do this.
- Allow Downgrading to 1.6 directly
Changes from 2.14.1 to 2.14.2
- +2PM: Fix Reset behavior on power cut
Changes from 2.14.0 to 2.14.1
- RGBWPM: fix reuse of PWM Timers (this fixes strange problems mainly in White mode)
- Addon Support for Gen3 Devices
- Match Device IDs to Stock to avoid updating problems
Changelog for 2.14.0
New Devices
- 1 Gen3
- 1PM Gen3
- 2PM Gen3
- i4 Gen3
- PlugS Gen3
- Plus Uni
Features:
- Sensor Support for ShellyPlusUni / ShellyUNI
- Initial Power Measurement Support on Mini1PMG3/+1PMMini
- +2PM and 2PMG3 Powermeter: Use original calibration values from Device partition
- +Plug S: Support for Neopixel Status LEDs
Fixes
- +2PM HW REV01: fix powermeasurement
- +1PM do not read power coefficients / enable updating
Note that reverting for PlugS Gen3 seems currently not possible, as we have no original firmware available.
Currently reverting for Mini 1/1PM Gen3 is disabled due to problems that could arise that brick the device. Please check the corresponding support issue.
Note: If you come from stock then please be sure to update to latest stock (1.5.1!) before using this firmware
Full Changelog: 2.14.0...2.14.3