0.1.0a35: a wallbox at its own address gets its own capability test
A wallbox added at its own network address (found by Search my network)
can now run the wallbox capability test itself, without an inverter beside it:
- Allow it under Configure on the wallbox's entry: May it write to the
wallbox, with a car charging?, and optionally the highest charging current
the test may offer (10 A if left empty, never more than the wallbox's
rating). It writes nothing until you switch it on. - Then choose Extended test (single run) in Diagnosis: mode and press
Diagnosis: start. Without the switch, the run only reads, and says so. - Extended test (auto repeat) repeats it on its own, at most every 15
minutes, whenever a check still missing can be answered. Most checks need a
car charging; until one is, it waits and writes nothing. A charge in
progress is interrupted by some checks. Diagnosis: stop ends it, and
so does a restart. - Every setting a run changes is put back and read again. The test sensors,
Diagnosis: next attempt and Diagnosis: tests, clear history work as
on an inverter entry.
Nothing changes for a wallbox your inverter entry reads through its WiNet-S or
its Wallbox address option.