0.1.0a33: more capability tests, readings checked over days, the connection
The extended diagnosis tests more, and auto repeat now checks your readings
while it waits:
- Readings checked against each other. While Extended test (auto
repeat) runs, every minute the integration checks that the readings agree:
power against voltage times current, the daily energy counters against the
power that fills them, the lifetime counters against the daily ones, the
meter's phases against its total. This reads only, writes nothing, and
finds a sensor read with the wrong scale. The results count in the
Diagnosis: tests ... counters, and auto repeat stays on until each has
an answer, which can take a day and a night. - Settings no test wrote before are now tested without changing how your
house runs: backup mode and load control are written with the value they
already hold; each EMS mode is set once and put back at once; each number is
offered one step above its maximum, to record the limit your firmware
enforces. With the charge window permission, the second charging window is
checked while your schedule is off. - The battery start thresholds are tested by what the battery does.
- With auto repeat, the forced charge and discharge, the charge ceiling and
the feed-in limit are measured once by day and once by night.
Also:
- New: Connection on the device page says whether Home Assistant reaches
the inverter directly or through a communication module (WiNet-S), with the
address; for a WiNet-S, Visit opens its web page. - Renamed: Diagnosis: next start is now Diagnosis: next attempt, and
Diagnosis: extended test, skip established is now Diagnosis: skip
completed tests (on by default). - After an update that changes how a test works, that test runs again.
None of this has run on an inverter yet. Please send a diagnosis after a day
of auto repeat: Download diagnostics on the device page.