Fixed bugs:
- Temperatures for PCB and SoC were swapped in 0.9.2 release
- Sometimes exiting mode resulted in exiting overlay
Changes:
- Introduction of experimental configuration file, which allows changing exit button combo, Mini + Micro + FPS Counter + FPS Graph UIs, refresh rates. More explained here.
- Button combos are read from 3 different configurations files, the most important is status-monitor config, next config used by Ultrahand overlay, and last config for Tesla Menu.
- Now default combo button is
L + D-PAD Down + R Stick. If someone wants to bring back old combo, use status-monitor config file.
- Allow reading real frequencies from sys-clk 2.0.0_rc4+ sysmodule, if not installed showed frequencies in Mini and Micro modes are falling back to target frequencies
- Allow reading RAM load from sys-clk 2.0.0_rc4+
- Remove option to change refresh rate with button combo
- Remove option to change position of Mini and FPS Counter modes with button combo
- Show proper button icons in Full mode (only exceptions are general
UP,DOWN,LEFTandRIGHTbecause they include both Sticks and D-Pad) - If sys-clk 2.0.0_rc4+ is active, Micro mode shows next to frequencies instead of
@also△if real frequency is higher by 20 MHz than expected,▽if it's lower by 20 MHz,≠if it's lower by 50 MHz (seeing≠for longer than few seconds without any change suggests that your overclocking solution is bugged). - PFPS is now not showing in Mini mode
Thanks to @ppkantorski for PR #63
Edit: November 10th, 2023 18:04 GMT: Fixed positioning calculations for RAM in Micro and Mini modes when sys-clk is not working.
Edit: Novermber 11th, 2023 06:13 GMT: Fixed real frequencies and deltas overflowing above INT32_MAX