New Devices
- Arlec 12 speed tower fan #542
- Arlec 6 speed floor fan #541
- Arlec 19 speed wall fan #543
- Chanfok ceiling fan with light #546
- Inkbird iBBQ-4BW cooking thermometer #548
- Simple dimming lightbulb #557
- CC curtains #523
- Yieryi YY-W9909 / pH-W3988 water quality monitor #555, #562
- Ultenic air fryer #556
- Generic warm/cool white lamp #571
- Kogan bidet #559
- Loratap RR500W switch #586
- Arlec 2400W panel heater #590
- Arlec 2200W panel heater #578, #590
- CBI Astute smartswitch #563
- Zemismart roller shade #566
- PH-W218 water quality monitor #580
Improvements to existing devices
- Shinco 30D: swap auto and continuous modes, high and low fan speeds and make secondary entities accessible #509
- Silvercrest kettle: make timer optional to improve compatibility, swap warm and boil #516
- Klarta humidifier: humidity settings off-by-one, set spray range #520
- Arlec thermostat: map manual switch and climate on/off differently #535
- RGBCW light: make timer optional to improve compatibility #549
- Ledkia fan: allow speed to go down to 0 #561
- Catit fountain: add range back to time remain sensors so they can be inverted #501
- TOMPD 63LW: make energy reset a boolean #577, #388
- Moebot: make some dps optional, and change password type #573
- YYM aroma diffuser: also support GX aroma diffuser #581
- Inkbord sous vide: make some dp optional for compatibility with Silvercrest SSVSS 1200 A1 #582
- smartswitchv1: add optional overcurrent sensor for Gosund EP2 #592
General improvements
- Bump tinytuya to 1.12.2 release
- vacuum: add stop command support #588