Highlights
Cisco 24-port front panel (#33)
Cisco-SMB 24-port switches (Catalyst 1200 / CBS350) number their copper ports Gi1..24 and their uplinks Te1..4 on separate ranges, with uplink ifIndexes often far from the copper block. The front panel now detects this layout by name and lays the four SFP+ uplinks onto slots 25..28, instead of mis-reading the ifIndex gap as a 48+4 chassis. Detection is conservative — it needs a real 24-port copper bank, an uplink, a consistent naming prefix and unique numbers, otherwise the previous behaviour is unchanged. Thanks to @rhysjoseph for the report and the hardware testing on Catalyst 1200 / CBS350.
Interface-tag port names
An interface tag on an IF item now supplies the port name when ifName/ifDescr are absent and the item name is a bare number — the case some Netgear templates produce. A real interface name still takes precedence.
Map no longer starts blank after a stale filter
A severity filter saved in an earlier session could match none of the nodes now on the map, leaving it looking empty on load. Such a filter is now discarded on the first populated render. A filter you set deliberately, and a map that is genuinely empty, are left untouched.
Runs on Zabbix 7.0 LTS, 7.4 and 8.0. Install the main module; the dashboard widgets are optional.