jontofront/ecoNET-300-Home-Assistant-Integration v1.3.4-alpha.1

on GitHub

⚠️ Pre-release for testing

This alpha is for testing ecoSTER room thermostat setpoints (#236). It is built from PR #254, which is not merged yet.

What's new

• ecoSTER setpoints as number entities: every connected ecoSTER panel gets editable setpoints on its ecoSTER N device.
  • Room thermostat N day setpoint (STER_TEMP_DAY_N), enabled by default
  • Room thermostat N night setpoint (STER_TEMP_NIGHT_N), enabled by default
  • Party, holiday and antifreeze setpoints, created but disabled by default
• Values and limits (10-35 °C, 0.1 °C step) come from /econet/editParams. Changes are written with /econet/newParam.
• If the ecoNET module has no editParams endpoint, the integration retries after 1, 3, 9 and 27 minutes and then stops until the integration is reloaded. Other entities are not affected.

Install with HACS

1. Enable the HACS Pre-release switch for ecoNET300 Home Assistant integration. It is disabled by default; find it under Settings → Devices & services → Entities.
2. Update to v1.3.4-alpha.1, or open HACS → ecoNET300 → ⋮ → Redownload and pick v1.3.4-alpha.1.
3. Restart Home Assistant.

To go back, use Redownload and pick v1.3.3, then turn the Pre-release switch off.

Full changelog: v1.3.3...v1.3.4-alpha.1