ihrapsa/KlipperWrt v1.0

KlipperWrt v1.0

on GitHub

Mainsail and Fluidd extroot filesystem for the Creality Wi-Fi Box running OpenWrt.

Each archive comes preinstalled with either fluidd v1.14.0 or Mainsail v1.6.0, Klipper, Moonraker, mjpg-streamer for webcam stream and Fry's timelapse component for taking frames and rendering the video.

STEPS:

• Make sure you've flahsed/sysupgraded latest .bin file from /Firmware/OpenWrt_snapshot/ or down below.
• Format an sd card as ext4 and untar one of the archive to its root: eg: sudo tar -xzvf fluiddWrt.tar.gz -C /mnt where /mnt is the path where the sd card is mounted on your linux pc. Might be different so double-check.
• Do the Wi-Fi step if you haven't done it already
• Do the extroot part ❗ EXCEPT ❗ this line: mkfs.ext4 /dev/mmcblk0p1 (otherwise you'll format it again)
• ❗ SKIP ❗ swap step since it already comes inside the archive
• Reboot

Setting up your printer.cfg

• put your printer.cfg inside /root/klipper_config
• delete these blocks from your printer.cfg: [virtual_sdcard], [display_status], [pause_resume] since they're included inside client.cfg
• move all your macros to client_macros.cfg
• add these 2 lines inside your printer.cfg:
  [include client.cfg]
[include client_macros.cfg]
• Done

Notes:

• If the box doesn't connect back to your router wirelessly connect to it with an ethernet cable and setup/troubleshoot wifi.
• timelapse is set to autorender which might take a while to finish after a long print. You might set it to autorender: False under [timelapse] block inside moonraker.conf. Check here for how to set your TIMELAPSE_TAKE_FRAME macro or TIMELAPSE_TAKE_PARKED_FRAME inside your slicer layer change.