Home Assistant Operating System
Build System
- Use Genimage for declarative image layout (#3388) @sairon
- Bump docker/build-push-action from 5.3.0 to 5.4.0 (#3405) @dependabot
- Bump docker/login-action from 3.1.0 to 3.2.0 (#3399) @dependabot
Raspberry Pi
ℹ️ Some Raspberry Pi users have reported system lockups and reboots with some Z-Wave and Zigbee USB adapters. This is an unresolved bug of the dwc_otg driver in the Raspberry Pi kernel. If your systems reboots or locks up during Z-Wave or Zigbee initialization, you can use the DWC2 driver by adding dtoverlay=dwc2 to config.txt. See #3362 for details. Only do these adjustments if your device locks up and reboots with HAOS 12.3 or newer with USB devices connected.
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
- RaspberryPi: Update kernel to 6.6.31 - stable_20240529 (#3400) @sairon
Home Assistant Yellow
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
- RaspberryPi: Update kernel to 6.6.31 - stable_20240529 (#3400) @sairon
- Linux: Update kernel to 6.6.32 (#3394) @sairon
Home Assistant Green
- Linux: Update kernel to 6.6.33 (#3415) @sairon
- Fix writing to eMMC in U-Boot on Green (#3412) @sairon
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
- Use U-Boot tarball for all boards (#3361) @sairon
Open Virtual Appliance
- Linux: Update kernel to 6.6.33 (#3415) @sairon
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
- Bump buildroot to update openvmtools to 12.3.0 (again) (#3370) @sairon
Generic x86-64
⚠️ Fujitsu Esprimo Q920 fails to boot with GRUB bootloader distributed in this OS release, updating to 12.4.rc1 may cause a boot failure and manual intervention might be needed, see #3348 for details.
- Linux: Update kernel to 6.6.33 (#3415) @sairon
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
Hardkernel ODROID
ℹ️ For ODROID-N2 (and Home Assistant Blue) this release reverts U-Boot update which is believed to be the cause of some intermittent issues when booting from eMMC. If you had any trouble previously after an update to OS 11.5 or newer, please see #3227 and help us with tracing this issue.
⚠️ Please note that some new eMMC modules with the Kingston chips are not supported yet - this is tracked in #3250.
- Linux: Update kernel to 6.6.33 (#3415) @sairon
- Temporary revert ODROID-N2 U-Boot to 2023.01 to fix eMMC issues (#3409) @sairon
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
- Use U-Boot tarball for all boards (#3361) @sairon
ASUS Tinker
- Linux: Update kernel to 6.6.33 (#3415) @sairon
- Set tty0 in cmdline as the default preferred console (#3402) @sairon
Khadas VIM Series
- Linux: Update kernel to 6.6.33 (#3415) @sairon
- Set tty0 in cmdline as the default preferred console (#3402) @sairon