-
ATTENTION: New BSB_lan_config.h configurations! You need to adjust your configuration when upgrading to this version!
** Webserver port is now defined in #define Port xx
** IP address is now defined in #define IPAddr 88,88,88,88 form - note the commas instead of dots!
** Special log parameters 20002 to 20006 have changed, see BSB_lan_config.h for their new meaning -
Added new virtual parameter 701 (Präsenztaste) which enters reduced temperature mode until next timed switch
-
Added Brötje BOB device family (138), including many new parameters!
-
Added Brötje SOB26 device family (28)
-
Added Elco Aquatop 8es device family (85)
-
Added Elco Thision 13 Plus device family (203)
-
Added Weishaupt WTU 25-G familiy (50)
-
Added output for absolute humidity (g/m3) for DHT22 sensors
-
New schematics for Arduino/Raspberry board layout
-
Included support for W5500 Ethernet2 shields. Activate definement ETHERNET_W5500 in BSB_lan_config.h
-
Including two-stage oil furnaces BC-counters and logging - please note that logging parameters have been adjusted, see BSB_lan_config.h for new values!
-
Added new options for commands /P and /S to allow specifying a different destination device during runtime
-
Added new configuration definement CUSTOM_COMMANDS which includes BSB_lan_custom.h at the end of each main loop. You may use custom_timer (set to current millis()) and custom_timer_compare to execute only every x milliseconds.
-
Bugfixing SD-card logging in monitor mode
-
Bugfix for setting hour:time parameters via webinterface