CHANGELOG

General Info

Binaries for each configuration and PCB design are at the end of this page.

• For Raspberry Pi Pico (RP2040) you need to download the .uf2 files starting with pico_piconesPlus.
• For Raspberry Pi Pico w (rp2040) you can download the .uf2 files starting with pico_w_piconesPlus. Although you can also use the pico_piconesPlus binaries on the Pico w if you don't mind the blinking led.
• For Raspberry Pi Pico 2 (RP2350) you need to download the .uf2 files starting with pico2_piconesPlus for ARM or pico2_riscv_piconesPlus for Risc-V.
• For Raspberry Pi Pico 2 w (RP2350) you can download the .uf2 files starting with pico2_w_piconesPlus for ARM or pico2_w_riscv_piconesPlus for Risc-V Although you can also use the pico2_piconesPlus binaries on the Pico w if you don't mind the blinking led.

Click here for tested configurations.

See setup section in readme how to install and wire up

3D-printed case designs for custom PCBs

Raspberry Pi Pico and Pico 2 PCB

https://www.thingiverse.com/thing:6689537.
For the latest two player PCB 2.0, you need:

• Top_v2.0_with_Bootsel_Button.stl. This allows for software upgrades without removing the cover. (*)
• Base_v2.0.stl
• Power_Switch.stl.

(*) in case you don't want to access the bootsel button on the Pico, you can choose Top_v2.0.stl

Waveshare RP2040-Zero and RP2350-Zero PCB

https://www.thingiverse.com/thing:7041536

Waveshare RP2040-PiZero

https://www.thingiverse.com/thing:6758682

v0.27 release notes

• Added second PCB design for use with Waveshare RP2040-Zero or RP2350-Zero mini development board. The PCB is designed to fit in a 3D-printed case. PCB and Case design by @DynaMight1124.
  Based around cheaper but harder to solder components for those that fancy a bigger challenge. It also allows the design to be smaller.
• Added new configuration to BoardConfigs.cmake and bld.sh to support the new configuration for this PCB.

Fixes

• Pico 2 W executables added to the release.

All changes are in the pico_shared submodule. When building from source, make sure you do a git submodule update --init from within the source folder to get the latest pico_shared module.