[3.0.0] March 18 2021

ESP32 version based off ESP-ESP v2.1

Power settings, disabling BLE and turning off Wifi sleep
Rx and Tx counts to Heartbeat MQTT payload
Ethernet support
id to info command to show only a heatingcircuit
add sending devices that are not listed to 0x07
extra MQTT boolean option for "ON" and "OFF"
Support for chunked MQTT payloads to allow large data sets > 2kb
External Button support (#708) for resetting to factory defaults and other actions
new console set command in system, set ethernet <profile> for quickly enabling cabled ethernet connections without using the captive wifi portal
Added in MQTT nested mode, for thermostat and mixer, like we had back in v2
Cascade MC400 (product-id 210) (3.0.0b6)
values for wwMaxPower, wwFlowtempOffset
RC300 thermostat temp -1 to clear temporary setpoint in auto mode
Syslog port selectable (#744)

changed how telegram parameters are rendered for mqtt, console and web (#632)
split show values in smaller packages (edited)
extended length of IP/hostname from 32 to 48 chars (#676)
check flowsensor for tap_water_active
mqtt prefixed with Base
count Dallas sensor fails
switch from SPIFFS to LITTLEFS
Added ID to MQTT payloads which is the Device's product ID and used in HA to identify a unique HA device
Increased MQTT buffer and reduced wait time between publishes
Updated to the latest ArduinoJson library
some names of mqtt-tags like in v2.2.1
new ESP32 partition side to allow for smoother OTA and fallback
Network Gateway IP is optional (#682)emsesp/EMS-ESP
moved to a new GitHub repo https://github.com/emsesp/EMS-ESP32

Firmware Installation

Follow the instructions in the documentation on how to install the firmware binaries in the Assets below.