This is a beta release based on v2.6.0-beta version.
Changes
- Initial support for LIDL/Silvercrest motion sensor #3736 #3779
- Merry Christmas with LIDL led stripe #3776
- Fix Aqara Opple switches not receiving button events #3768 #3780
- Support for new version of Trust ZYCT-202 (ZLL-NonColorController) #3733
- Support Benexmart 3 gang switch variant (TS0043) #3724
- Support Saswell SEA801 new variant (_TZE200_c88teujp) #3730
- Initial support for LEDVANCE aka Sylvania BR30 and A19 #3721
- Initial support for Samsung water leak sensor (moisturev4) #3737
- Initial support for LIDL/SilverCrest contact sensor (TY0203) #3773
- Restore support for Schlage Connect Smart Deadbolt (B3468) #3677
- Allow receiving door lock operation completion #3751
- Improve end-device pairing #3769
- Improve HTTP accept header parsing of API versions; Reintroduce colorcapabilities in API version v1.1 #3703
- Fix heating setpoint changeable for all Eurotronic Spirit Zigbee thermostats #3680
- Avoid fake device creation for TUYA light #3774
- Enhancements and improvements for Sonoff, Bitron, Develco and others #3732
- Button maps enhancements #3781
- Support USB device creation inside Docker when required cgroups permissions are set for the container marthoc/docker-deconz/#298
- Fix handling ZDP Simple Descriptor NotActive status code.
Firmware
| Hardware | Version |
|---|---|
| ConBee II | 0x26680700 |
| RaspBee II | 0x26680700 |
- Fix end-device management;
- Fix creation of invalid neighbor table entries on incoming commands;
- Fix joining loop in deCONZ when certain invalid parameters were set;
- Raised source routes table size from 32 to 64;
- Routing table size is 170.
This firmware update is also recommended for ZHA, zigbee2mqtt and WebThings users.
In this release it needs to be installed manually as described in the Wiki.
A special thanks to all contributors of the deCONZ Github community.