New FluidNC release 3.7.12
- We moved the config file examples to a new repo.
- The Tablet UI now uses a jog for the probe pull off.
- Added the ability to suppress messages sent to a uart_channel. This reduces bandwidth and CPU load on both ends for messages that are typically not needed by pendants and displays.
- Fixed a homing issue where undefined axes would warn about not being homed.
- Fixed a hardware UART definition issue to improve timing accuracy on higher baud rates.
- (for devs) New $sd/listJSON and $localfs/listJSON commands for listing directories via serial. Useful for pendants. Directory listing via HTTP is unchanged.
Note: The WebUI has changed. You need to manually install the new file from the release. We hope to make this simpler some day. If you have your config file backed up, you can also do a full install and then reupload your config file.
http://wiki.fluidnc.com/en/installation#upgrading-firmware
The current WebUI file can be downloaded here.