The in-radio Tailscale relay that AetherSDR installs from Waveforms → Install… → Remote Access (Tailscale) (RFC #6271; PR #7345). Setup guide: Tailscale Remote Access.
These are packages for the radio, not an AetherSDR release. AetherSDR downloads the one your radio takes, and refuses any other bytes.
| Radio | File | SHA-256 | Size |
|---|---|---|---|
| FLEX-6000 series (legacy waveform) | AetherTailnet-0.5.4-native.ssdr_waveform
| fb8a3bf8d43639f6a540bde84a12a3c5a94f5b9f22948fc32615c834670e7f0f
| 9,194,004 bytes |
| FLEX-8000 series and Aurora (container) | flex-tailnet-shim-0.5.4.tar.gz
| 28406e62b2211d93b3b63119e2693179cbcc3762aa76dcece12893ea52afea18
| 8,088,544 bytes |
Changes since 0.5.3:
- SmartSDR for Mac connects over the tailnet by IP. In the successful reply to a client's
infocommand, the shim replaces the radio's LAN address (ip=) with the tailnet address the client dialed, so a client that follows that address reaches the radio instead of timing out (#6984, #7345). Only an IPv4 tailnet address is substituted; nothing else in the radio's replies changes.
Both packages rebuild byte for byte from this tag with Go 1.27.1, CPython 3.14 and zlib 1.3.2. See tools/flex-tailnet-shim/README.md.