github abrocoma/PS5-CachyOS test-75hz-p1472
Test kernel: 75 Hz / non-standard monitor modes (p1472)

pre-releaseone hour ago

Test build, not a normal release. For testing monitors whose 75 Hz (or other non-standard) mode is missing on the PS5.

Based on kernel 7.3.4-p1472 (same as the 2026-11-17 image), with two changes in the PS5 HDMI mode filter:

  • Pixel clock: when the monitor's EDID gives no max TMDS clock, the limit was 165 MHz. It now uses the EDID's own range limit (max 340 MHz). A typical 1080p 75 Hz mode needs about 174.5 MHz.
  • Sync polarity: non-standard timings were only accepted with +hsync -vsync. They're now accepted with any polarity and sent to the HDMI chip as +hsync -vsync.

Tested on a PS5 Fat (FLAVA3) with a Samsung Odyssey G5: 1440p 60/120/144 Hz, VRR and HDR unchanged; a +hsync +vsync mode (1280x1024 @ 75 Hz) shows a picture at 75 Hz. Side effect: older monitor modes (1024x768 @ 75 Hz etc.) can now show up in the mode list too. The new kernel line sudo dmesg | grep 'range limit' shows the EDID value that was read.

FreeSync/VRR stays limited to the modes it worked on before (1080p 60/120, 1440p 60/120, 4K). A newly unlocked mode like 1080p 75 Hz runs at a fixed refresh rate.

Needs the 7.3.4-p1472 kernel (Update PS5 CachyOS, or update-kernel.sh).

tar --zstd -xf ps5-kernel-p1472-75hz-test.tar.zst
sudo sh test-75hz/install-75hz-test.sh

Restart PS5 Linux, then pick the mode in System Settings → Display. Undo: sudo sh test-75hz/install-75hz-test.sh --rollback, then restart. To keep the kernel but turn the clock change off: add hdmi.range_clock=0 to cmdline.txt.

Don't miss a new PS5-CachyOS release

NewReleases is sending notifications on new releases.