What's Changed
- Stability improvements to NetControl exploit by @earthonion
- Standardize shellcode by @Al-Azif in #42
- Add built-in AIO Fix by @Al-Azif in #44
- including time with logs + make it save it on logs.txt by @m2k7m in #49
- stopping input when pressing jailbreak button by @m2k7m in #82
- fixed auto load error (fn not found)
- fixed config getting overwritten
New Contributors
Full Changelog: v1.3...v1.4
This release focuses on NetCtrl stability improvements for 12.50-13.00 users, with more UI fixes to come.
Note
Auto Loader and Auto Close should not be used until the next release.
Lapse 7.00–12.02 AIO fixes as kernel patches, replacing the AIO fix payload and 12.50–13.00 kernel patches by @Al-Azif
fake-signin.bin has been added to payload menu.
The success rate of NetCtrl is around 60–90%. This is near the expected success rate of 12.5x BD-J with NetCtrl. Speed has also increased.
Getting 2–4 failures should not discourage you from continuing to try, as even Lapse can fall into a few bad runs.
After further optimization beyond the initial two commits, testing between @DrYenyen and @earthonion resulted in a 10/10 success rate for @earthonion and 7/10 for @DrYenyen when using NetCtrl. Please leave feedback on the Vue Discord linked in the readme.
Further improvements to NetCtrl should not be expected, but may still be attempted.
Note
If you see a “Reboot and try again” message or a “Buffer cannot be zero” message or similar, shut down and reboot once.
After a failure, it attempts to clean up to avoid a kernel panic (hard shutdown) and allow the user to safely shut down manually and try again. Additionally, you should shut down and try again if the application crashes.
Please read the FAQ for internet and general troubleshooting information.