Shared links
New
- Shared links: read-only views for people without an account. Made in
Settings, Shared links, by a global administrator only. A link shows one
page, a slideshow of pages across routers, one Dashboard card, or a sensor
feed for Home Assistant. Each link has an expiry (or Never), a viewer cap,
an optional address list and the sites allowed to embed it, and can be
edited or revoked at any time. Asked for in
#165, thanks
@PhillipSlabbert. - Refused changes are in the audit trail. An attempt to change something
without permission leaves a row, rate limited so a flood cannot bury it.
Changed
- Sign-in is always required. The Require sign-in switch is gone from
Settings, Authentication: a dashboard that can change routers should not be
open to anyone who reaches it. An install that had switched it off now asks
for a login like any other, and a fresh install still goes to first-run
setup. Raised in #165,
where the switch was found to have had no effect since 0.8.0, thanks
@PhillipSlabbert.
Fixed
- MikroDash can no longer be shown inside another website's frame. Every
page, the login page included, now tells the browser never to display it in
a frame, so a hostile page cannot overlay MikroDash and trick a signed-in
user into clicking something. If you were embedding MikroDash in another
dashboard with an iframe, that stops working; a supported, view-only way to
embed is a shared link (above). - The Security Profiles section on Wi-Fi Networks no longer flickers. On
a router with both the newer wifi menu and the legacy wireless menu present
but no interfaces in either, the page switched between the two every
second. Reported in
#166, thanks
@oykawa.