Changelog 11.9.1
- Binary Inputs: Set internal pull-up resistor enabled by default.
Changelog 11.9.0:
- Binary Inputs: Set internal pull-up resistor disabled by default to avoid potential damages because most commercial hardware uses external pull-up resistors. However, if internal pull-up resistor is needed, now it must be declared explicitly with
"p":1; but in DIY projects, it is recommended to use external pull-up resistors and capacitors. - Binary Outputs Actions, PWM, NRZ, Status LED GPIO, IR GPIO, RF GPIO and HLW Output pins: Added option to set GPIO Output Open-Drain.
- Garage Door: Applies time margen to beginning of movement too.
- Power Measure: Added virtual service modes to work with Free Monitor.
- Fixes some network locks.
- HAA Installer 6.6.1:
- Fixes some network locks.
Read Wiki for more info.