Windows game streaming, written in Rust. Built for Radeon and Moonlight.
Download Windows x64 installer · Portable ZIP
New in 3.2.1
Rubylight 3.2.1 lets Stream in the browser pick AV1, HEVC or H.264 and stream in Firefox (#66, #67), keeps fixed-rate streams steady when a game runs faster than the stream, lets pause and resume commands run side by side, and fixes the Wake-on-LAN check in the console.
Stream in the browser
- Stream in the browser picks the codec, resolution and frame rate. The Stream page now offers AV1, HEVC and H.264 at every resolution and frame rate the host's encoder takes, limited to what the browser can receive. It starts with a codec the browser decodes in hardware at 1080p60 and remembers your choice (#67).
- Firefox streams in the browser. Firefox refused the host's offer with "SIPCC Failed to parse SDP: Min is not smaller than max". The page now leaves out the Samsung TV line that caused it (#66).
Streaming
- Steadier fixed-rate streams beside other windows. When a game runs at two to four times the stream rate (120 Hz at 60 fps), the host now follows the game's own frame timing, so another window's updates no longer take the place of the game's frames or hold back the frames after them. Measured on the RX 7900 XT at 1080p60 with a 120 Hz game: beside a window animating at 30 fps, end to end p95 was 0.6 ms lower and picture age p95 1.0 ms lower; on a quiet desktop, 0.9 and 1.9 ms lower. Frames ready for the encoder waited under 0.5 ms at p95 in most runs, against 1.4 to 2.3 ms before.
Apps
- Pause and resume commands no longer block each other. Rubylight waited for each pause or resume command to finish, so a script that keeps running while the game is paused (Apollo's auto-pause script with
pause.ahkandresume.ahk) held back the resume and was killed after two minutes. These commands now start without waiting, as on Apollo.
Console
- Wake-on-LAN check reads the adapter again. Settings → This PC showed "Allow this device to wake the computer" and "Only allow a magic packet" as Unreadable on every PC, so no adapter ever showed as ready and the console never offered to switch them on. It now reads both, and offers the fix when they're off.
Tested. On the RX 7900 XT at 1080p60 with a 120 Hz game, alternating old and new builds for 30 s each, fixed-rate streams had a lower end to end p95 in every pairing: 10.66 to 10.02 ms beside a window animating at 30 fps, 12.31 to 11.44 ms on a quiet desktop, and 10.30 to 10.08 ms at 1080p120, where the host claimed about 0.2 % fewer frames (119.8 to 119.9 fps against 120.1). Firefox 159 rejected the host's real offer exactly as reported in #66 and accepted it with the page's edit, answering H.264 and AV1; AV1 and H.264 at 1080p60 streamed through the Stream page from an isolated host. The full host suite, clippy and the release build pass.
Install or upgrade
Disconnect your stream and close host-launched games, then run the installer. Your settings, paired devices and game library are preserved. Open the console at https://localhost:47990.
Full release notes · Build and tests · Code signing policy · Host validation