This is version 1.9.7.53, which has been improved and fixed based on user feedback and experience, and has added some new features.

Improvements

1.During PA calibration, add the entire printing area to the leveling area.
2.When the “wipe tower” is enabled, it will also be added to the list of excluded objects.
3.Starting from this version, multiple types of hot beds are supported. When you enable this feature, you can individually configure the bed temperature for the hot bed you choose.

Bugfix

1.Fixed the bug that the UI was displayed in some Linux operating systems.
2.Fixed an issue where the first startup would stall after adding models.
3.Fixed the issue of incorrect line width display in the preview version of the calibration module.
4.Fixed the time interval issue of sending print tasks from multiple/single devices.
5.Fixed the issue where the filament preset was exported as empty.

Misc

1.Removed some unnecessary options to prevent unexpected errors in slicing.
2.Added new filament configuration and modified the printing configuration of general consumables to achieve better printing results.
3.Optimized the tool head docking point in the smooth mode of time-lapse photography.
4.Change the tool head stop position at the end of Plus 4 printing.
5.Optimized the control logic of the chamber fan.
6.Optimized the logic of canceling sending tasks.
7.Optimized the jump logic during calibration to reduce repeated page refreshes.