Warning
Please read the changes carefully before updating Cosmos.
Note
Instructions for installing and upgrading Cosmos can be found here.
Major Changes
This release focuses on stability... and turtles 🐢 🐢
We have some great commits to help improve the stability of Cosmos including:
- Zram will now retry the device reset instead of dying silently at boot by @kyleinoregon in #312
- Kalico now lazy loads all modules by @justinh-rahb in KalicoCrew/kalico#958
- Increase max velocity in resonance tester to help shaper calibration succeed by @jamesturton in #245
- Increase likelyhood of pid calibrate succeeding by @suchmememanyskill in #341
We have also had some more AFC love with the following:
- Support BoxTurtle by @suchmememanyskill in #327
- Grumpyscreen now supports Canvas and BoxTurtle via AFC by @shawn-makes-stuff and @pellcorp in pellcorp/grumpyscreen#282
Other Notable Changes
- change cut depth to 3.5 and make it a var by @Bad-Hackerman in #311
- Revert TMC autotune for z and e by @suchmememanyskill in #321
- Wipe after print; reconcile KICK and CLEAN_NOZZLE; Don't unload after cancel by @suchmememanyskill in #329
- Implement eject for canvas by @suchmememanyskill in #331
- Revert moonraker service type to mjpegstreamer by @suchmememanyskill in #336
- Remove BED_MESH_CLEAR from CLEAN_NOZZLE macros by @suchmememanyskill in #337
- Enable canvas feature when canvas is detected by @suchmememanyskill in #335
- Remove unretract during CLEAN_NOZZLE/KICK by @suchmememanyskill in #345
- Make end-of-print retraction configurable by @suchmememanyskill in #347
New Contributors
- @kyleinoregon made their first contribution in #312
Full Changelog: 26.08.0...26.09.0