Warning
These are development builds. Read the changes carefully before applying a beta firmware.
Caution
Delete your existing bed mesh when upgrading to/from a beta build. Otherwise your print plate may be damaged.
If you are using fluidd or an external service which connects to moonraker you will have to specify port :7125.
You may have to clear your browser cache before accessing mainsail after this update.
Note
Instructions for installing and upgrading Cosmos can be found here.
What's Changed
- Draft FAQ added by @robertsamples in #61
- Moonraker: add BusyBox-compatible ip wrapper by @shawn-makes-stuff in #68
- Reintroduce doom by @suchmememanyskill in #67
- Add screws tilt calculate and macro by @Bad-Hackerman in #65
- klipper: Improve performance by @timiv in #70
- Add Z-offset for load cell probe by @jaimbo in #73
- Sims/remove camera led bridge by @suchmememanyskill in #75
- Switch to ustreamer for camera stream by @suchmememanyskill in #84
- Add G-code macros for grumpy extrusion and retraction by @Atomique13 in #57
- Add thermal zone configuration for CPU monitoring by @Atomique13 in #88
- Merge bed.cfg, mainboard.cfg, misc.cfg and toolhead.cfg into machine.cfg by @suchmememanyskill in #95
- Update cosmos splashscreen by @jamesturton in #98
- Fix webcam links and switch to MJPEG Adaptive by @CobreDev in #100
- Add is_non_critical flag to bed MCU configuration by @Atomique13 in #104
- Add Z clearance step before XY homing in homing override by @suchmememanyskill in #97
- Replace nginx with httpd by @jamesturton in #99
- Add config file to configure updating from nightly by @jamesturton in #106
New Contributors
- @robertsamples made their first contribution in #61
- @shawn-makes-stuff made their first contribution in #68
- @Bad-Hackerman made their first contribution in #65
- @Atomique13 made their first contribution in #57
- @CobreDev made their first contribution in #100
Full Changelog: 0.0.2...0.0.3