- A new screen asks for its first tiles. Once a new screen was in Home Assistant, its starting screen said "Waiting for Tessera", while it was really waiting for someone to choose its tiles. Tessera now tells a screen that it has no tiles for it yet, and the screen says what to do in three short steps: open Tessera in Home Assistant, pick tiles for the screen, by its own name, and press Save & send. A small tile in one of the Tessera mark's colours stands before each step. The words take the largest of the screen's faces that leaves them air, with the Tessera lockup over them where the glass has room for both: large words without the lockup on the 2.8- to 4.3-inch screens, the lockup over them on the 10.1-inch. The tiles take their place as soon as they are saved.
- The starting screen's hint after half a minute without Home Assistant no longer asks whether the screen was added under Devices & services. Tessera adds it by itself since 0.4.73, so the hint says that, and that Home Assistant has to reach the screen at its address.
- A long hint on the 2.8-inch ran into the version number at the foot of the starting screen. The number now steps aside when the words need the room.
- Every screen is offered this firmware, 0.45.0.
- Tested: the starting screen rendered from the real firmware on the CYD lying down and standing up, the 4-inch Guition, the Waveshare 4.3-inch and the 10.1-inch Guition, light and dark, before and after. On the bench, a Waveshare 4.3-inch without tiles runs 0.45.0 with this app and got the hello that asks for its first tiles. Every Python, C++, editor and WASM preview check, the layout audit included. Firmware builds on ESPHome 2026.9.0 for the CYD (87.9 % of its slot), the 4-inch Guition, the 10.1-inch Guition and the Waveshare 7-inch, and on 2026.6.2 for the CYD (89.7 %). The steps on glass were not looked at yet.