- New board: the M5Stack Tab5 (#79, PR #150), the 5-inch 1280 x 720 tablet with an ESP32-P4, in its ST7121 variant (the factory log says "Detected ST7121 touch controller"). Three rows of three tiles, or four rows when you choose that in New screen, camera tiles and pictures, the Wi-Fi hotspot with its QR code, and the battery's voltage and level as sensors in Home Assistant. Other Tab5 variants are not covered yet: check the factory log first (docs/TAB5.md). It needs ESPHome 2026.7 or newer, which the app has. Thanks to @Heronimonimo, who built and tested it on his own Tab5.
- The Waveshare 4B dims over the whole range (#158). Everything under about 74 % brightness was dark, so night and standby brightness turned the screen off instead of dimming it. On this board GPIO4 is not a switch for the LEDs but the analog dim input of their driver (an AP3032), behind a filter, and the driver stops altogether once that level passes about 1.78 V. At the 5 kHz it ran (as Waveshare's own examples do), the ripple behind the filter crossed that line long before the average did. The pin now runs at 300 kHz, the dimmest step stays just inside the range where the driver runs steadily, a brightness of 0 is still dark, and the light no longer applies ESPHome's gamma, which pressed everything under 30 % onto the dimmest step. Thanks to @EythorE for the schematic reading and the measurements on a real panel.
- A diabetes icon for a tile or the top bar (#156, PR #160),
mdi:diabetes, under Other in the icon picker. Thanks to @Heronimonimo. - A power key on the media card, and volume keys (#146). A player that Home Assistant can turn off (a TV, an AV receiver, a speaker with a power switch) has its power key at the top right of the card, where every other card keeps its keys, and only then: Spotify and other players that cannot be turned off show none. A player whose state Home Assistant only assumes gets both power keys, as in Home Assistant's own dialog, and the power keys use its icon. The row at the bottom of the card is new: volume down, a shorter slider and volume up, round keys like the screensaver's, and after them the player's inputs and its library, which moved down from the top bar. Every tap on volume down or up is a step, also when you tap fast. Hold volume down to mute, and the next tap on either key takes the mute off. A media tile over a whole page has the same row, without the percentage it showed.
- A player's card is plain black while nothing plays, without the grey to black gradient it still had. A cover's own colours still colour the card while it plays.
- A camera picture on an alert stays within the screen's own full-screen picture, also on a large glass.
- Every screen is offered this firmware, 0.39.0.
- Tested: every Python, C++, editor and WASM preview check, and the layout audit of every card on every board shape. Firmware builds on ESPHome 2026.9.0 for the CYD (87.0 % of its slot), the Guition, the 10.1-inch Guition, the Waveshare 7-inch, the Waveshare 4B and the Tab5. The media card, its power key, the new volume row and the tile over a whole page were rendered from the firmware on the CYD, the Guition, the Waveshare 4.3 and the 10.1-inch Guition. Not tested on glass in this release: the Tab5 was tested by its contributor, the 4B dimming by its reporter's measurements, and the volume keys and power key only in renders.
- Update the app first, then the screens, as always.