-
More room for firmware on a screen with 4 MB of flash (the CYD, the CYD with an ILI9342 and the Hosyond 4-inch). Their firmware had filled its update slot. These boards now have a partition table of their own with update slots of 2,031,616 bytes where ESPHome's own table has 1,835,008, about a tenth more. The room comes from the area for settings, which was 448 KB and almost empty: the settings now have 16 KB in a place that was unused, and they fill about a quarter of it.
-
A screen you already have moves by itself. Update the screen as you always do. After the update Tessera sends it the new table and the screen restarts once more. Everything it kept comes along: the touch calibration, the settings of the settings page, which way it hangs. The screen copies all of it to the new place first and compares the copy both ways, and it asks for the table only when the copy is exact and ESPHome has confirmed the new firmware, a minute after the update. That makes this one update a few minutes longer.
-
An install over USB keeps the settings too. It writes the new table at once, and the screen fetches its settings from the old place the first time it starts.
-
A firmware that outgrows the old slot still reaches a screen with the old table. Tessera then installs a small firmware in between that can take the table, sends the table, and installs the screen's own firmware. The glass is dark for a minute or two while it does. Nothing needs this yet: today's firmware fits both tables.
-
A new diagnostic sensor on these boards, Screen flash, says which table a screen has:
widewhen it has the new one. -
No other board changes: their firmware stays 0.33.0 and they are offered no update.
-
One thing to know: the table itself is written in a fraction of a second, and a screen that loses its power in exactly that moment needs an install over USB afterwards. docs/FLASH_LAYOUT.md has the whole story.
-
Update the app first, then the screens, as always: an older app does not know the way over the small firmware in between.
-
If you build or flash your screens yourself (ESPHome Device Builder, the command line or USB): docs/UPDATING_4MB_SCREENS.md says what to do, in three ways. The same page is on the Tessera website under Docs.