github MaxGramser/homeassistant_espscreen screens-v0.4.44
ESP Screens 0.4.44 (firmware 0.25.0)

one month ago
  • A heat/cool range on the thermostat card, as a band. A thermostat set to a range (heat/cool, with a low and a high
    target) showed its two targets as two small numbers above one "Target", and one pair of -/+ keys that moved whichever
    end was last tapped, which only a fainter shade told apart. The card now shows one big number and, under it, the
    device's whole span as a band with the degrees along it: the heat colour runs from the minimum up to the low target,
    the cool colour from the high target up to the maximum, and the bare track lies between them, as Home Assistant's own
    thermostat draws it. A knob stands on each end; tap one and the number, the -/+ keys and the knob take that side's
    colour, so what a key moves is always in sight. While the room is colder than the low target or warmer than the high
    one, the part the device has to cover is drawn in full with a mark at the room's temperature.
  • A thermostat with one target draws exactly as before, and the tiles are unchanged. The band is LVGL's scale widget,
    new in every board's firmware (LV_USE_SCALE); the editor's preview draws it too.
  • Tested: the CYD, the Guition 4848S040, the JC8012P4A1 and the Waveshare 7 build with ESPHome 2026.9.0 (the CYD
    image is 1,715,216 B, 93.5 % of its slot, 0.6 % more than firmware 0.24.0 for the scale widget), and the CYD with
    2026.6.2 (95.4 %). The card was checked in the firmware preview on every board shape, lying down and standing up,
    with the room inside, below and above the range, in °C and °F, and with single-target thermostats unchanged to the
    pixel. The bench Guition took the firmware over the air and came back; the band itself was not yet looked at on glass.

Don't miss a new homeassistant_espscreen release

NewReleases is sending notifications on new releases.