What's new
Full stacking lip
Bins can have the full lip of the original Gridfinity profile, with its support under the inner tip, besides the light lip. The top of the lip can also be left untrimmed, ending in the sharp edge of the original profile instead of cut flat 0.6 mm lower. Both are in the new Lip type dropdown and Trim lip top checkbox, and the bin dialog shows the exact bin height that follows from them.
Export with colored labels
Right-click a bin or baseplate and pick Gridfinity export. It exports the selected bodies, or every visible bin and baseplate, into one 3MF, or into an STL or STEP file each, at the origin with the bottom at zero. In the 3MF the letters of outline labels are painted with a color index of your choice, so Bambu Studio, OrcaSlicer and PrusaSlicer could automatically detect that and preselect a different color for them.
Outline label letters also show in a color of their own in Fusion, which can be changed for every bin in the design's appearances.
Bin placement
New bins snap to the free grid spot closest to the origin, next to bins already there, as before, or can be centered on the origin with the new Placement option. A centered bin is centered again when rebuilt (#131).
Label tab top offset
Tab top offset sets how far the label tab is below the top of the bin, 0.5 mm as before by default, now can be changed to any value between 0 and 2 mm. The label goes down with the tab, and the dividers between compartments are lowered by the same amount.
Chamfered magnet sockets
Magnet sockets of bins and baseplates have a 0.5 mm chamfer around their opening, so magnets go in easier and the first layer doesn't squish into the hole.
Documentation
The wiki now lives in the repo and documents every option of the bin and baseplate dialogs, with pictures, cross sections and GIFs. A contribution guide explains how to set up, test and document a change.
All changes
Bins
- Full lip of the original Gridfinity profile, on plain, low, shaped and shelled bins
- Trim lip top can be turned off to keep the sharp top edge of the lip
- The lip type dropdown shows the profile of each lip
- Placement: snap to a free grid spot or center on the origin (#131)
- Tab top offset lowers the label tab and the compartment dividers, up to 2 mm
- 0.5 mm chamfer around the opening of magnet sockets
- Outline label letters show in a color of their own in Fusion
- The dialog shows the exact bin size, following the bin xy clearance and the lip trim
Baseplates
- 0.5 mm chamfer around the opening of magnet sockets
- Sides with padding get no connection holes, like sides with half cells, no other plate meets them there. Seams between the pieces of a filled area keep theirs (#150)
- The connection hole inputs are turned off for Light and Full plates, only Skeletonized plates get the holes
- Clearance between plates is now Plate edge clearance, measured per plate edge like every other clearance, 0.05 mm by default. The gap between plates stays the same, older configs, settings and saved defaults are halved when read
- Extra bottom thickness is now Bottom padding and Vertical clearance under bins is now Top trim, only the labels changed
Settings and workflow
- Gridfinity export in the right-click menu: one 3MF with the label letters painted for slicers, or an STL or STEP file each. The folder, format and color index are kept for the next time
- Gridfinity settings, rebuild and clone also show when right-clicking the component a bin or baseplate was generated in
- Configs and bins from earlier versions without the new settings take the dialog's values
Full changelog: v2.4.2.0...v2.5.0.0