GeorgHo/SpoolStudio v3.0.9

Spool Studio v3.0.9

on GitHub

Spool Studio v3.0.9

Changes

• Updated the Paxx12 SpoolLink readiness logic for newer firmware versions.
• Removed the misleading Assignment command readiness check from Settings.
• Toolhead status now depends on the printer Spoolman/SpoolLink components instead of the incomplete Moonraker gcode/help command list.
• Manual toolhead assignment now tries the real Paxx12 assignment commands directly:
  • SET_PRINT_FILAMENT_CONFIG ...
  • fallback: SET_SPOOL_ID ...
• After a manual assignment, Spool Studio still verifies that the printer reports the expected spool ID.
• RFID write readiness no longer incorrectly depends on the hidden assignment command check.

Why this changed

With recent Paxx12 firmware, the assignment command may no longer be listed in Moonraker gcode/help, even though manual toolhead assignment still works. Spool Studio now follows the actual firmware behavior instead of treating the missing help entry as a hard error.

Notes

• Built for the Paxx12 SpoolLink workflow where the printer identifies spools by the physical tag UID stored in Spoolman.
• Tested against the current Paxx12 1.6.0 generation.
• If manual assignment fails, the app now reports a real write failure instead of asking for the old AFC Lite related setup.