EmixamPP/linux-enable-ir-emitter 7.0.0 on GitHub

What's Changed

Complete rewrite in Rust, bringing more robustness and performance.
New TUI interface for improved user experience and understanding.
tweak command is now accessible via the configure command, as the UVC Tweaker tool.
Better balance between configuration search time and exhaustiveness.
Full rootless capabilities.
--config, --log and --grey-devices cannot be combined with each other or with a command anymore.

More debug commands to help users to report issues: --config, --log, --grey-devices.
migrate command to migrate the configurations from the v6 to the v7 format.
setup-howdy command to integrate with howdy in PAM, and to allow the polkit password prompts, sandboxed since polkit 126.
When executed by PAM, the run command uses the configuration of the user being authenticated, so the PAM line does not need --config.
Prebuilt binary for ARM 64-bit (aarch64) processors.

The devices are identified by their USB vendor, product, serial number, interface and index, instead of their /dev/v4l/by-path/ path, for better persistence. The configurations saved with a /dev/... path by the beta versions are still applied, and are replaced when configuring the device again. This fixes the IR camera not enabled after a reboot when it shares its USB device with the RGB camera.

OpenCV is not used anymore for capturing V4L video stream, because of unreliability, and compatibility issues across distro.
Removing test command.

Packagers, please read the packaging guidelines.