Radio codes now name the chip that sent them, devices made from radio Remotes send, and the panel keeps infrared and radio hardware apart.
Radio in the Candy Drawer
The Candy Drawer, at the top right of the Mirror, now prints radio as well as infrared: presses, HAIR's own radio sends, and their echoes. Each radio block shows the band and the code as a .sub you can paste into the Clipper.
Every received block also says whether HAIR already knows the code. known: names what holds it, a device command, a trigger or a remote's row. new means HAIR has not met it before. New chips filter by IR or RF and by Known or Unknown.
Radio static is counted on one line per receiver. Turn on the Static chip to see it capture by capture, which helps when a remote isn't being picked up. docs/rf.md has a section on reading a radio block.
Clearer radio sends
- A command a device has no emitter for now says which code, which kind and which device, for example "Power is a radio code and Bench Plug has no radio transmitter. Add one in the device's settings." When the device's transmitters can't send the code's band, it says so with the band.
- Under a radio code's send count, the Assign dialog and the radio code editor say where the number comes from: as many times as the remote sent it when captured, or a usual count when that wasn't measured.
Remotes made from radio codes
"Make a Device" from a Remote that holds radio buttons made commands that could not send. A Remote's radio buttons now keep their own code, the way infrared buttons do, so a device made from the Remote sends. Remotes and devices made on 1.2.0 are repaired on the first start after the update where HAIR still holds the code; a button it can't repair is marked, and pressing it once on the remote fixes it.
A file button on the add tiles
The add tiles on the Devices page have a plus button and a folder button. The folder opens a file to import, the same as dropping it on the tile.
Radio remotes name their chip
Radio codes now show the chip family of the remote that sent them, in the same protocol pill infrared codes use: EV1527, PT2262, HT12E, HT6P20 and KeeLoq. Hover the pill for the address and button. Codes HAIR does not recognize show no pill. If a label looks wrong for your remote, open an issue with a capture from the Candy Drawer.
Infrared and radio kept apart
When you make or edit a radio Remote or device, the receiver and transmitter lists show only radio hardware, and infrared work shows only infrared. A device of type Other now reads "Radio Device" or "IR Device" on its card, by what it holds.
Clearer chips
A bright dot on an emitter or receiver chip now means it is picked; chips that are not picked show a dimmer dot, and offline is still a hollow ember ring. Picked chips are the same green everywhere, and a capture device's card shows its state again: gray until it has a switch, gold when ready, green while listening.
Fixes
- A Remote made from the Sniffer, Clipper, Plucker or Closet shows on the Devices page right away instead of after a reload.
- A radio row in the Sniffer that a later press moves to a better carrier now shows the new band at once instead of after a reload.
Full changelog: CHANGELOG.md