cryinkfly/Autodesk-Fusion-360-on-Linux v7.6.6

☕️ Created a Matrix room! 🍵

on Codeberg

A discussion room has been created to speed up the development of Autodesk Fusion 360 on Linux and enable a better exchange of thoughts and ideas.

This Matrix room was created by the two GitHub users @dzervas and @9ary . ❤️️

And at this point many thanks to both of them! 👏

So exchange ideas and much more if you want! 🏗

There is also another piece of news! @dzervas created another project on Fusion 360 on GitHub, directly addressing Fusion 360 QT under/build. You can find more information in his blog post. 💡

So have a look there too. :+1: